Boiler repair in Worksop

Worksop has the widest spread of boilers of any town we cover, and the fault you have is largely predicted by the part of town you live in. The colliery housing at Manton was built to one pattern and a lot of it still runs back boilers behind gas fires, or the first combis that replaced them in the late 1990s — both now at the age where parts fail every winter. The post-war council housing across Kilton and the rest of Manton is sealed combis of mixed makes and mixed quality. Gateford and the estates towards Shireoaks are modern private housing where the first-generation combis fitted with the houses are reaching fifteen to twenty years and failing on electronics and heat exchangers. Around the Priory and the town centre the Victorian property has long flue runs and awkward condensate routes that produce their own faults in cold weather. Half an hour each way means a second visit is expensive for everyone, so we ask the right questions when you call and load the van accordingly.

What goes wrong with Worksop boilers

• Manton's back boilers and first-generation combis

  The pit housing at Manton is the largest concentration of back boilers left on our patch, and the combis that replaced many of them are twenty-five years old. We carry the common Baxi Bermuda parts and the fans, PCBs and diverter valves for the older Worcester, Potterton and Glow-worm combis, and we tell you plainly when an appliance has reached the point where the repair money is better put towards a replacement.

• Gateford's combis reaching end of warranty

  The 1990s and 2000s houses at Gateford were fitted with combis that have now run fifteen to twenty winters. The failures are predictable — plate heat exchangers, fans, PCBs, pumps — and mostly economic to repair once. We fix them at a fixed price and give you the replacement figure alongside it so the next decision is informed.

• Cold-weather lockouts in the older town centre

  Victorian property near the Priory and along Bridge Street has condensate pipes routed outside and flues with long internal runs, and both produce lockouts in a cold snap. A frozen condensate is a quick fix; a flue fault needs the run checked for joints and fall before anyone blames the fan.

• Doing it in one visit from thirty minutes away

  A forgotten part in Worksop costs an hour of travel, so we do not make a diagnostic visit and then a repair visit as a matter of course. We ask for the make, model and symptom when you call, carry the likely parts, and price the repair on site before the case comes off.

Repairs we do most often in Worksop

• Manton — back boiler gas valve

  Baxi Bermuda behind a living-room fire, no heat, in a colliery semi. Gas valve replaced from the van, gas rate and flue checked, and the customer given the cost of a kitchen combi for when the appliance finally goes.

• Gateford — plate heat exchanger on a 2004 combi

  Hot water running warm then cold in a Gateford detached. Plate heat exchanger replaced rather than the whole boiler, at a fixed price agreed first, with a scale reducer fitted so it does not recur as quickly.

• Kilton — fan on a Glow-worm combi

  Ignition failure and a fan fault code on a post-war semi's combi. Fan replaced on the first visit — one of the parts we always carry to Worksop — and the flue checked while the case was off.

• Near the Priory — frozen condensate and a re-route

  Lockout in the first frost in a Victorian terrace with the condensate down an outside wall. Thawed, restarted, then re-routed internally so it did not happen the following week.

For how we approach boiler repair generally — what is included, how we price it and what happens on the day — see our boiler repair page. For everything else we do in the area, seeour work in Worksop.